PENGARUH VARIASI TEMPERATUR NORMALIZING TERHADAP BESAR BUTIR DAN KEKERASAN MATERIAL BAJA KARBON AISI 1035

Suhardan Suhardan, R Kohar

Abstract


Mechanical properties of steel do not only depend to its chemical composition but also its micro structure. This mechanical property can be modified with heat treatment processes, one of them is by using normalizing method. This process is able to manipulate both micro structure and particle size. In order to investigate the influence of Normalizing temperature, An AISI 1035 steel is treated by Normalizing with various temperatures from 820 to 880 ⁰C. Since each sample is treated by same method, the microstructure of each sample is also similar. In addition the difference variation of normalizing temperature among each sample causes the variation of grain size. The increasing of temperature Normalizing causes the increasing of its grain size. The influence of of grain size is investigated by doing Rockwell Hardness Test. Based on the result, steel which has bigger grain size has higher hardness property.

 

Keywords: : Mechanical Characteristics, Micro Structure, Normalizing, Grain Size


Full Text:

Article 2(2)(2019)

References


ASM, 1972. Metal Handbook Atlas of Micro Struktur of Industrial Alloys. Ohio: Metal Park.

ASM, 1973. Metallography, Structure and Phase Diagrams. Ohio: Metal Park.

Suhardan, 2006. Pengaruh Perlakuan Panas Dengan Bermacam Pendinginan Terhadap Sifat Mekanik. Palembang: Jurnal Wacana Teknologi Kopertis Wilayah II.

AT Prakoso, OF Homzah, S Hariadi. Analisa Kegagalan Pada Drill Pipe. Turbulen:Jurnal Teknik Mesin 1(1). Juni 2018. e-ISSN: 2656-0186

USS, 1951. Atlas of Isothermal Transformation Diagrams. USA, Pittsburg.

Liu, Q., Zhang, Q., Zhang, M., & Zhang, J. (2017). Effects of grain size of AISI 304 on the machining performances in micro electrical discharge machining. Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 231(2), 359–366.

Karl-Erik Theelning, 1974. Steel and Its Heat Treatment. Butterworths: Bopor Handbook.

Harmer E.Davis, 1982. The Testing of Engineering Materials. New York: Mc.Graw-Hill Book Company.

George F. Vander Voort, 1984. Metallography Principle and Practice. United States Of America: Mc.Graw-Hill Book Company.

Sidney H. Avner, 1987. Introduction to Physical Metallurgy. Singapore: Mc.Graw-Hill Book Company.




DOI: http://dx.doi.org/10.36767%2Fturbulen.v2i2.550

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

Published by Mechanical Engineering Study Program, Faculty of Engineering, Universitas Tridinanti Palembang

Contact Us:

TURBULEN: Jurnal Teknik Mesin

Phone/WhatsApp/sms : +62821-7853-3625 or +62852-6805-4099

email:jurnal.turbulen@univ-tridinanti.ac.id

e-ISSN: 2656-0186